Version: 1.2 (12.2022)
Project description
The holy grail in flight modelling and a long-time dream of the designers of this Sea Harrier can now become reality.
As functional as necessary and as close to the original as possible. This printable aircraft is based on more than 10 years of modeling experience and can now, with your help and ambition, be further developed into a Vertical Takeoff and Landing model. - Or you just have fun with a perfectly flying airplane.
-
Sea Harrier (300x300x300)
98,00 €incl. 7% VAT
Add to cart
General printing recommendations
| Printer size | 25 cm x 25 cm x 25 cm (e. g. Bambu Lab X1C) – 105 mm EDF version 30 cm x 30 cm x 30 cm (e. g. Creality CR10) – 90 mm EDF version |
| Enclosure | Not necessary |
| Slicer | Cura, Bambu Studio (aktuelle Version) |
| Filaments used | LW-PLA (e. g. colorFabb), PLA, PA-CF low-warp Nylon (e. g. colorFabb) |
| Filament diameter | 1,75 mm |
| Nozzle diameter | 0,40 mm |
Special printing recommendations for all LW-PLA components
Most components of the jets sold here are designed and optimized for a stable lightweight construction with LW-PLA. Since this foaming filament requires special parameters for successful printing, which vary from printer to printer and also from slicer to slicer, you should make your own printing tests in advance. You can find many tutorials and tips on the Internet and on YouTube.
The basic default settings we use with a Bambu Lab X1C and Bambu Studio as slicers are listed here.
You can start with that for now.
| Print bed temperature | 60° Celsius |
| Nozzle temperature | 242° Celsius |
| Cooling | Yes 100% |
| Print speed | 30 mm/s |
| Layer height | 0,20 mm |
| Support | Yes (Zickzack), for angles > 60° |
| Flow rate | 42% – 50% |
| Filling pattern | Gyroid (3D) |
| Filling level | 3% – 5% |
| Retract | Without |
| Number of outer layers | 1-2 |
| Printing plate adhesion | Brim, 8 lines |